uftags.blogg.se - Packet Tracer 8.3.1.2 Skills Integration Challenge

HQ(config)# interface s0/1/0 HQ(config-if)# encapsulation ppp HQ(config-if)# ppp authentication chap HQ(config-if)# exit HQ(config)# username ISP password cisco HQ(config)# interface s0/0/1 HQ(config-if)# encapsulation ppp HQ(config-if)# ppp authentication pap HQ(config-if)# ppp pap sent-username HQ password cisco HQ(config-if)# exit HQ(config)# username NewB password cisco eBGP However, it must be configured before the link will come up between HQ and NewB. Note: The ppp pap sent-username is not graded by Packet Tracer.

Create a user NewB with the password of cisco.

Configure the WAN link from HQ to NewB using PPP encapsulation and PAP authentication.

Create a user ISP with the password of cisco.

Configure the WAN link from HQ to the Internet using PPP encapsulation and CHAP authentication.

The user EXEC password is cisco and the privileged EXEC password is class.

Note: Only HQ, B1, B1-S2, and the PCs are accessible. Security configurations include SSH, port security, switch security, and ACLs.

Other technologies include NAT, DHCP, static and default routing, EIGRP for IPv4, inter-VLAN routing, and VLAN configurations. In this comprehensive CCNA skills activity, the XYZ Corporation uses a combination of eBGP and PPP for WAN connections. VLAN Configurations and Port Mappings VLAN Number Ip dhcp excluded-address 172.31.40.1 172.31.40.8.3.1.2 Packet Tracer – CCNA Skills Integration Challenge Addressing Table Device Verify all devices can now ping each other and Scripts.Configure R1 as a DHCP client so that it receives an IP address from the ISP network.

Click Fast Forward Time to speed up the process. Note: DHCP address assignments may take some time. Verify that each PC has an address assigned from the correct DHCP pool.Prevent the first 10 addresses from each pool from being distributed to end devices.Configure the DNS server 209.165.201.14 for each pool.Configure DHCP to provide the default gateway address.Assign the appropriate addresses to each pool.Configure R1 to act as a DHCP server for the VLANs attached to S2.Subinterface names should match the VLAN number. Configure all non-trunk ports on S2 as access ports.Create VLANs on S2 and assign VLANs to appropriate ports.Using the information in the tables above, implement the following requirements: In this culminating activity, you will configure VLANs, trunks, DHCP Server, DHCP relay agents, and configure a router as a DHCP client. Topology Addressing Table VLAN Port Assignments and DHCP Information Scenario Instructor Note: Red font color or Gray highlights indicate text that appears in the Answer copy only.

Packet Tracer – Skills Integration Challenge ( Instructor Version)